Release notes for 0.5.5b (2011-12-04)

New features:

  • optimal bridging direction is detected for more bridges
  • flow width is auto adjusted to avoid leaving gaps at the border of solid regions
  • customizable speed for small perimeters
  • customizable multiplier for the flow rate used when bridging

Improvements:

  • important settings are marked in bold – new users can start printing by changing only those ones
  • infill segments are now connected to allow better sticking to the perimeters

Bugfixes:

  • 0.5.4 was less tolerant than 0.5.3 about dirty STL models